Image 1 of 10
Image 2 of 10
Image 3 of 10
Image 4 of 10
Image 5 of 10
Image 6 of 10
Image 7 of 10
Image 8 of 10
Image 9 of 10
Image 10 of 10
Product details
C3 LED lights provide compact flood-pattern lighting options for snowbike, enduro, and dual-sport builds where space and electrical capacity matter. The current range lets the rider choose among a small low-draw light, a conventional light-bar format, and a wider high-output Side Shooter.
Manufacturer: C3 Powersports
Light choices
The 2-inch Compact Light is rated at 10 watts and emphasizes minimal size and low draw. The 4-inch Light Bar is rated at 20 watts and uses a familiar bar format with broad illumination. The 40-watt Side Shooter is the highest-output choice and adds a stated 170-degree spread for wide forward coverage. Select the exact light shown above; do not choose solely by housing appearance.
Electrical planning
Available stator output and the motorcycle’s other electrical loads must be considered before adding a light. The 40-watt option can be unsuitable for two-strokes or motocross motorcycles with limited charging capacity. Use a properly fused circuit, correct polarity, sealed connections, and wire sized for the selected load.
What’s included and installation
This listing supplies the selected light. Mounting brackets, switches, and bike-specific C3 delay-relay wiring harnesses are sold separately unless the chosen option explicitly says otherwise. Some wiring knowledge is required. Mount the light where steering, controls, cables, and the number plate remain clear; a low-and-rear position may require additional bar height. Route wires away from exhaust heat, sharp edges, pinch points, and moving parts, then verify the beam position and full steering movement before riding.
