Image 1 of 7
Image 2 of 7
Image 3 of 7
Image 4 of 7
Image 5 of 7
Image 6 of 7
Image 7 of 7
Product details
C3 CenterFlow handlebars use circulating engine coolant to warm the bar itself, delivering strong, even hand heat without adding bulky control hardware at the grips. A cockpit-mounted flow valve lets the rider adjust coolant flow and heat output while riding.
Manufacturer: C3 Powersports
Why it matters
The bar is purpose-built rather than converted from a standard off-the-shelf handlebar. Its coolant passages and machining are concentrated in the low-stress center area between the mounts. C3 specifies 7000-series aluminum, a profiled wall, and a neutral bend of approximately 9 degrees upsweep and 14 degrees backsweep. Threaded ends are built in for C3 FORCEFIELD handguards.
What’s included
The kit includes the CenterFlow 1 1/8-inch handlebar, its integrated flow-control valve, braided 1/4-inch coolant lines, push-to-connect plumbing, and the connection hardware shown for the selected configuration.
Fitment and installation
A thermostat is required. C3 thermostat kits provide the intended bypass and return connections; using another thermostat can require extra fittings and custom plumbing. The bar does not fit 7/8-inch mounts. Some motorcycles need compatible 1 1/8-inch risers, and solid one-piece bridged lower clamps are not directly compatible. Select the exact configuration offered above and contact Moto365 if the bike or clamp arrangement is not listed. After installation, follow the motorcycle manufacturer’s coolant-fill procedure and recheck coolant level after the first heat cycle.
